Horizontal Sidewall Sprinklers Model GS258, K-factor 5.6 S Quick Response

Model GS258, 5.6 K-factor Horizontal Sidewall Sprinklers  Quick Response

• GENERAL DESCRIPTION 
  • Horizontal sidewall sprinklers aredesigned for installationalongawall or thesideof abeamand are commonly used instead of pendent or upright sprinklers due to aesthetics or building construction considerations, where piping across theceiling isnotdesirable.
  • Corrosion resistant coatings, whereapplicable,are utilized toextend the lifeof copper alloysprinklers beyond that which would otherwise be obtained when exposed to corrosive atmospheres. Although corrosion resistant coated sprinklers have passed the standard corrosion tests of the applicable approval agencies, the testing is not representative of all possible corrosive atmospheres. Consequently, it is recommended that theenduser beconsultedwith respect to the suit-ability of these corrosion resistant coatings for anygivencorrosiveenvironment. Theeffectsof ambient temperature, concentration of chemicals, and gas/chemical velocity, should be considered, asaminimum,alongwiththecorrosivenatureof the chemical towhichthesprinklerswillbeexposed
• NOTICE
  • The Model GS258 Sprinklers described herein must be installed and maintained in compliance with this document and with the applicablestandardsof theNational FireProtection Association (NFPA), inaddition to the standards of any authorities having jurisdiction. Failure todo so mayimpairtheperformanceof thesedevices.
  • The owner is responsible formaintaining their fire protection systemanddevices in proper operating condition. The installing contractor or sprinkler manufacturershouldbecontactedwithanyquestions

• OPERATION
  • The glass bulb contains a fluid which expands when exposed to heat. When the rated temperature is reached, the fluid expands sufficiently to shatter the glass bulb, allowing the sprinkler to activate and water to flow

• TECHNICAL DATA
  • Sprinkler Identification : GS258
  • K-factor, gpm/psi½ (Lpm/bar½): 5.6 (80 L/min/bar^0.5)
  • Temperature Rating ºF (ºC): 5155°F (68°C) 200°F (93°C) 286°F(141°C)
  • Thread Size: 1/2 in. NPT
  • Sprinkler Orientation: Horizontal Sidewall
  • Working Pressure, psi (bar): 175 psi (12 bar)
• INSTALLATION 
  • Pendent Sprinklers (GS258): Install with the frame arms parallel to the branch line
  • Use the appropriate sprinkler wrenches to prevent damage during installation.
  • Maintain proper clearance from obstructions as per local fire codes and regulations.
• NOTE 
  • Step 1. With pipe thread sealant applied, hand-tighten the sprinkler into the sprinkler fitting.
  • Step 2. Wrench-tighten the Model GS258 Sprinkler using only the W-Type 34 Sprinkler Wrench as shown in Figure 2, and by fully engaging (seating) the wrench on the sprinkler wrench flats
  • Step 3. After installation, inspect the bulb of each Model GS258 Sprinkler for damage. In particular, verify that the bulb is not cracked. Replace damaged sprinklers.